Led Indicator Status - Ezviz C6T Rf Schnellstartanleitung

Setup
Step 1 Power-on
Plug the power cable into the camera, and then plug the power adapter into an outlet as shown
in the figure below. The LED indicator will flash red and blue when the camera is ready for
setup.
Power Interface
Turn on the C6T and let it power up. The camera will completely rotate side-to-side
and tilt up-and-down once.

LED Indicator Status

Blue Flicker: The network is properly
connected.
LED Indicator
Solid Red: The device is activating.
Slow Red Flicker: Invalid network connection.
Fast Red Flicker: MicroSD card or other error
occurred.
Alternating Blue and Red Flicker: Camera is
ready for Wi-Fi setup.
1
Power Outlet
Power Cable