Next Level Racing F-GT Pro Bedienungsanleitung Seite 7

A)
Tip: Do not fully tighten Bolts yet.
01
A) Align first Set of Support Arm Brackets on the Front Frame of the cockpit as shown above.
B) Bolt through Support Arm Brackets and loosely secure using M10 Bolts and Square Nuts.
A)
Tip: Do not fully tighten Bolts yet.
02 A) Align second Set of Support Arm Brackets on the Front Frame of the cockpit as shown above.
B) Bolt through Support Arm Brackets and loosely secure using M10 Bolts and Square Nuts.
A)
Tip: Evenly loosen Bolts on Support
Arm Brackets if tube ends do not fit.
03
A) Make sure Support Arm Brackets are roughly the same height. Insert tube ends of Support Arm into
Brackets. B) When happy with approximate height, tighten Bolts on Support Arm Brackets.
B)
B)
B)
7
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 1 x Set of Support Arm Brackets
• • 2 x M10 30mm Button Head Bolts
• • 2 x M10 Square Nuts
PARTS:
• • 1 x Set of Support Arm Brackets
• • 2 x M10 30mm Button Head Bolts
• • 2 x M10 Square Nuts
PARTS:
• • 1 x Support Arm