Using The Product - Laserpecker Lp5 Benutzerhandbuch

Using the product

Dual Red Dots Focusing (Manual Focusing)
Place the material on the Base plate. Initiate the preview mode or turn on the red dots
focusing mode in the machine se ings through App or PC software to observe the two
dots. Adjust the height of the Electric Stand until the two red dots coincide, and the focus
is successfully set.
Engrave using USB Flash Drive
After inserting the flash drive into the machine, the project files (.lpb) on the drive can be
selected using the PC software or mobile App to preview and engrave.
12
Emergency Stop
If errors or machine faults occur during material processing, press the emergency stop
bu on to disconnect and stop the processing.
Operation Access Control
To prevent others from using the machine, remove the security key to lock the processing
and related functions.
Insert the key to unlock the processing and related functions.