VEVOR YX-RGXB01 Anleitung Seite 7

Section 1:install the light stand
1.Remove the screw cap
protecting the screw
4.Fully extend the stand
7.Pull out the second section of
the pole upwards
10.Tighten the knob on the
bracket clockwise
SOFTBOX INSTALLATION
2.Loosen the knob on the
bottom of the light stand
counterclockwise
5.Tighten the knob on the
bracket clockwise
8.Tighten the knob on the
bracket clockwise
11.The bracket is installed as shown in the picture
- 7 -
3.Open the stand outwards
6.Turn the knob on the pole
counterclockwise to adjust the
height of the stand
9.Pull out the third section of the
pole upwards