Kidwell ROLLO Benutzerhandbuch Seite 9

• On a regular basis, verify if any elements of the product are broken,
• and check the state of fastening of bolts, nuts, etc.
• Do not install any objects [to the product] which could be dangerous to its proper
performance or any objects that could injure children.
• If damage is found, discontinue the use of the product immediately
• and keep the it out of children's reach until repaired.
• All of the product's components must be assembled properly; great care must be
taken to tighten the screws and nuts.
• The product does not have a brake.
• Do not use the product in any manner not specified in the manual.
• It is unacceptable to use the ride-on toy on roads where there is traffic, or any other
roads on which motor vehicles travel and other places that pose a risk to the health
and life of children.
• Do not operate the product on surfaces that are wet, slippery, sandy, gravely, etc. and
might potentially cause the risk of losing balance.
• Do not operate the product after dark, in mist or other weather which reduces visibility.
• Before using this product, make sure that the child understands how to operate it
correctly – including how to make turns and stop the bicycle.
• Do not leave the product exposed to train, snow or heat.
• For additional safety, installing features such as lights and reflectors is recommended.
• When driving, the child must keep both hands on the handlebars.
The figures and photographs are for reference only. The actual appearance of the
product may vary from the illustrations shown in the manual.
SPECIFICATIONS
• Suitable for children from 3 years of
age
• Maximum load up to 100kg
• Luminous LED wheels
• Non-slip seat and footrest
• Forwards and backwards movement
possible
• Lightweight and solid – it weighs just
3-4 kg
BICYCLE PARTS DESCRIPTION
A Bicycle body
B Bar with front wheels
C Rear wheel axle
D Locking plug – x2
E Nut – x2
F Socket wrench
• PU wheels that do not scratch
surfaces
• Attractive design
• Suitable for both indoor and outdoor
use
• Fully compliant with EN-71
requirements
G Rear wheel – x2
H Open-end wrench 10 mm
I Steering wheel plug
J Wheel plug X – x4
K Wheel plug Y – x2
L Handlebar
9