Homend FUNCTIONALL 2804H Gebrauchsanweisung Seite 36

Every question in life has an answer.
It is our primary wish that you have no problem while using your
practical food processor. Nevertheless, we have prepared a list
which indicates the problems that you can overcome with small
interventions. We hope it would be helpful.
Problem Possible cause
The robot cover may have
not been closed tightly.
The
The power cord is not
appliance
connected to the socket
is not
You may not have pressed
the start button.
functioning.
The robot cover may not
have been fitted into the unit.
More material than
The appliance
capacity may have been
is not chopping
well. placed.
Blender motor body
The robot cover
may be installed.
cannot be
He did not press the lid
removed.
opening buttons on the
sides. you can be
The blender motor
Blender tabs may not have
frame cannot be
entered the slot.
fitted onto the
robot cover.
The blender
Engine casing release
motorframe
button not pressed
cannot be
you can be.
removed.
The blade cannot The blade may not be
seated properly on the
be fitted in place
turning shaft.
3 4
Solution offer
Close the robot cover tightly.
Connect the power cord into
the socket.
Press the start button.
Place and lock the robot
cover into the unit tightly.
Reduce the amount of
ingredients.
Remove the blender motor
frame from the housing.
Press the cover release
buttons.
To remove the blender motor
frame, press the button on
theside and turn the frame
counterclockwise.
Insert the blender lugs fully
into the slot and turn the
blender motor
frame counterclockwise.
Make sure that the blade
is fully fitted in place.
F U N C T I O N A L L