Explanation Of Symbols - Masterchef 527015 Bedienungsanleitung

•
The maximum food temperature that the appliance can come in contact with is 80˚C.
•
The supplier is not responsible for any damages resulting from improper connection or use of the
product.
Warning
•
Incorrect use may result in bodily injury. Use this product only in accordance with this manual.
Never attempt to modify the product in any way.
•
Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. Only use a
moist cloth to clean the motor unit.
•
Risk of injury in case of improper use! The cutting blades are very sharp; exercise extreme caution
and avoid direct contact with the cutting blades.
•
Risk of burns! Never use the product with boiling water or hot grease.
Caution
The appliance is intended for domestic and similar use. The product is not intended for commercial use.

EXPLANATION OF SYMBOLS

Read the user manual.
The manufacturer of the
packaging contributes to the
costs of the waste separation
and recycling system "Green
Dot".
If you notice any transport
damage when unpacking the
product, please contact you
dealer without delay.
This product has a double
insulation and does not require a
safety earth connection. It has
been designed so that it can
safety be used as is without the
need for any additional safety
features (cases, covers, etc.)
Declaration of Conformity.
Products marked with this
symbol comply within the
European Economic Area (EEA).
The EU Declaration of Conformity
can be requested from the
manufacturer.
The packaging can be reused or
recycled. Please dispose properly
of any packaging material no longer
required.
This product is safe to be used in
contact with food.
The packaging can be reused or
recycled. Please dispose properly
of any packaging material no longer
required.
This appliance is fitted with a BS
1363 plug (Type G) and suitable for
use with the a Type G socket.
Declaration of Conformity.
Products marked with this symbol
comply within the United
Kingdom. The UKCA Declaration of
Conformity can be requested
from the manufacturer.
2