VEVOR DB22 Bedienungsanleitung Seite 7

STEP 4：Using the lint brush and a vacuum, clean the back of the dryer as
well as the surrounding area.
STEP 5：Disconnect the vent from the back of the dryer. Using the shop
\AC/Blower adapter, attach it to the vent using duct tape. If the vent
compresses when the vacuum is turned on, or the vacuum ramps up, this
indicates there is a blockage. At this point use the heavy Blockage
Removal T I to attempt to remove the debris. NOTE: The Blockage
DO
Removal T I is not for use with a drill, only to be used by hand with
DO
extensions.
STEP 6：Attach the Drill Adapter to a cordless drill.
- 6 -