Cherry Ergo WheelMouse wirelessoptical Schnellstartanleitung Seite 4

1.2 Positioning the receiver on the desk
If your desk has a wooden surface, you can
achieve optimal receipt conditions by positioning
the receiver horizontally.
If your desk has a metal surface, you can achieve
optimal receipt conditions by positioning the
receiver vertically. You can use the base of the
receiver to this purpose.
1.3 How to connect the receiver to your
PC via the USB port
1 Remove the USB-PS/2 adapter from the USB
connector of the receiver cable.
2 Connect the receiver connector with the USB
port.
1.4 How to connect the receiver to your
PC via the PS/2 port
You must first switch off the PC if you connect the
receiver to the PS/2 port of the PC by means of the
adapter.
Connect the PS/2 connector of the USB-PS/2
adapter with the PS/2 port of the PC.
2 Simultaneous operation of
several mice
Interference may occur during transfer when oper-
ating several mice in close proximity to each other.
To prevent this, the individual signal transfer from
your mouse to your receiver must be activated.
4
2.1 How to activate the individual signal
transfer between the mouse and the
receiver
1 Briefly press the button on the receiver.
The LED of the receiver is activated and lights up
for approx. one minute.
2 Press the button on the underside of the mouse
with a pointed object (e.g. ballpoint pen) when
the LED lights up.
The LED of the receiver extinguishes. The indi-
vidual signal transfer is activated.
The data transfer between the mouse and the
receiver is indicated by the LED briefly flashing.
Following a battery change, the individual signal
transfer must be reactivated.
3 Installing the mouse under
Windows 95/98/ME/2000/XP
3.1 To install the software underWindows
95/98/ME/2000/XP
1 Place the enclosed CD-ROM in your
CD-ROM drive.
The CD-ROM starts automatically. The Ergo
WheelMouse wireless optical window is
opened.
- or -
If the CD-ROM is not started automatically,
select CD-ROM Drive | Software in the
Windows Explorer and double-click the file
Setup.exe with the left mouse button.
Installation begins.
2 If the CD-ROM starts automatically, click on the
entry Start software installation.
Depending on the settings of your Internet
Browser you can save or open the file.
3 If possible, select the option Open and click on
the OK command button.
- or -