BRC INOXTRAP 14 Bedienungsanleitung Seite 2

TUBES REMPLACEMENT
Before any form of servicing, ensure that the unit is disconnected from the mains supply.
To maintain the units efficiency, replace the UV LED bulbs every 24 months.
* Starters must be changed at the same time than tubes (see further instructions below).
Changing the tubes:
1. Unscrew the two rings of each tubes
2. Slide the rings toward the center of tubes
3. Take the tubes out by sliding down
* At this time, do the starters replacement and then go to the 4th step of the changing tubes instructions
4. Take of the rings of tubes and reserve them
5. Slide the rings on the new tubes
6. Put the new tubes in the device by sliding up
7. Screw properly the rings on each sides of the tubes
2
3
1
7
5
6
STARTERS REMPLACEMENT
Before any form of servicing, ensure that the unit is disconnected from the mains supply.
To maintain the units efficiency, replace the starters annually.
* Tubes must be changed at the same time than starters.
Changing the starters:
1. To be able to change the starters, the tubes must be removed
2. Unscrew the two waterproof caps of each starter
3. Unscrew the two starters to free them of their holders
4. Take the starters out by sliding down
5. Put the new starters in the device by sliding up
6. Screw the starters to their holders
7. Screw properly the two caps on each starter
Indice A
BRC SAS – 21 rue des coteaux de Grand Lieux – 44830 BOUAYE
22.11.2022
info@brcsa.com - Tel. 02 40 34 57 24 – Fax. 02 40 34 74 76 – www.brcsa.com
2/2