Pipeline BOX DNA60C Gebrauchsinformation Seite 13

PUFF TIME LIMIT
If the fire button is pressed for longer than 20 seconds, the device will automatically
interrupt the power output to prevent overheating or running the atomizer dry.
POLARITY PROTECTION
Always ensure the correct orientation of the battery when inserting it into the battery
compartment. If a battery is inserted with incorrect orientation, the built-in polarity
protection will prevent damage to the electronics. The device cannot be turned on or
charged in this condition.
CHARGING THE BATTERY
The PIPELINE BOX DNA60C features dedicated electronics that enable charging of an
inserted Li-Ion battery via the USB-C port. For this purpose, use only a high-quality and
appropriately rated charging cable/power adapter (not included).
We generally recommend using specialized external chargers for charging Li-Ion
batteries. Particularly for smaller cell types (e.g., 18500, 18350), their lifespan can be
significantly extended by using a correspondingly lower charging current (≤0.5 C)!
24 English
E R R O R M E S S A G E S
CHECK ATOMIZER
The device is unable to detect the resistance [Ω] of the attached atomizer/coil.
Please check for dirt or debris on the contact points between the atomizer and the device
and clean them if necessary. Ensure that the atomizer is screwed on flush and that the
positive pole of the atomizer makes contact with the device (adjust if necessary).
Inspect the coil of the atomizer (consider replacing if necessary).
SHORTED
The device detects a short circuit in the attached atomizer.
Please check the isolators of the atomizer. Inspect the coil of the atomizer
(consider replacing if necessary).
WEAK BATTERY
The output voltage of the inserted battery under load is below the set value
(default: 2.8 volts). Insert a charged battery or connect an appropriate charging cable/
power supply to the USB-C port of the device. An unusual frequency of this error message
often indicates a reduced battery capacity due to improper storage, handling, or intensive
use (consider replacing if necessary).
OHMS TOO LOW / OHMS TOO HIGH
The resistance [Ω] of the attached atomizer/coil is outside the allowable range
(0.15 Ω – 3.0 Ω). Check the coil of the atomizer (consider replacing if necessary).
English 25