EBERTH GW2-EB52 Bedienungsanleitung Seite 46

4. Move the choke lever to the "OFF" position and pull the cable slowly 1-2 times
without starting the engine.
Never pull out the entire rope and never let go of the rope from the pulled-out position
- return it evenly!
5. Move the choke lever to the "ON" position and pull the cable firmly and evenly
several times until the engine is running.
6. As soon as the engine has started, regulate the speed with the throttle lever and
slowly move the choke lever to the OFF position.
The motor has a centrifugal clutch. Power is only transferred to the drill when the
speed is increased.
The primary pump is not required for a warm start.
The clutch is retracted after approx. two hours of operation. Until then, clutch
slipping may occur. Keep the clutch free of oil and other moisture to ensure optimum
performance.
16
Figure 6
Figure 7
V. 1.2 EN