Technical Data; List Of Parts; Intended Use - BOMANN bz 9482 cb Bedienungsanleitung

• Keep CO2 cartridges out of the reach of children.
• Do not tamper with the cartridge.
• Avoid contact with the cartridge at freezing
temperatures (risk of frostbite) and do not use.
• Only use the 16g CO2 cartridges intended for the
dispenser. The use of other cartridges will invalidate
the warranty.
• Only dispense of the CO2 cartridge when empty.

Technical data

Model: BZ 9482 CB
Power supply: 220-240V AV/50Hz
Power: 72 Watt
Protection class: II
Dimensions (L x W x H
in mm): 480 x 300 x 450
Beer keg: Standard 5 litre party keg
Housing material: ABS
Contents, accessories and technical data subject to
changes without prior notice!

List of parts

1 Chiller
2 Lid
3 Lid opener
4 Keg holder
5 Keg tap
6 End of dispensing unit
7 CO2 feed valve
8 Beer tap
9 Tap handle
10 Collecting tray
11 Drip tray

Intended use

This dispenser serves for chilling dispensing beer from
standard 5 litre party kegs.
It must be used for this particular purpose only.
It must only be used in the manner described in these
operating instructions.
This beer dispenser must not be used for commercial
purposes.
Use for any other purpose is considered improper and
not for the intended purpose and can result in damage to
property and personal injury.
Bomann GmbH is not liable for any damage attributed to
improper use.
12 CO2 cartridge chamber
cover
13 CO2 cartridge holder
14 CO2 cartridge holder
15 Front tube cover
16 Pressure regulator
17 Main switch
18 LED temperature
indicator
19 Tools for removing keg
stopper
20 Universal adapter
21 Cleaning balloon
22 CO2 cartridge
16
Dear Customer,
Congratulation on the purchase of your beer dispenser. You
will now be able to enjoy cool, draught beer in the comfort
of your own home.
There are numerous beers to choose from available in 5
litre party kegs.
Before using the dispenser, please read the instructions for
use and safety information.
Installation
WARNING!
• Before fi tting or removing any parts, always
disconnect the plug from the mains socket!
1. Remove the beer dispenser from the packaging.
2. Place the beer dispenser on a stable, horizontal, level
and non-slip surface. Ensure that there is at least
10cm of space around the dispenser for optimal
operation.
3. Fit the collecting tray/drip tray.
Ensure that the collecting tray/drip
tray does not protrude beyond the
surface.
4. Fit the silicon ring in the threaded
part of the tap. Screw the tap tool
below the dispensing unit.
5. Attach the tap handle. When fi tting
the handle, ensure that the hole in
the bottom of the handle fi ts
exactly on the metal pin on the top
of the tap.
6. Clean the dispensing unit as described in the
instructions in Chapter "Dismantling and cleaning the
beer dispenser".
7. Check that the main switch at the back of the
dispenser is set to "0" and plug the plug into the
main socket.
8. Set the main switch to "I".
9. Check the LED indicator to ensure that the dispenser
is on.