Pyle PSS4EU Benutzerhandbuch Seite 3

PSS4
lets you connect up to four separate pairs of speakers to your stereo
receiver/ampli er. The control center is especially convenient if you have
speaker sets in di erent rooms and want to turn them ON and OFF inde-
pendently. You can enjoy the convenience and exibility of listening to multiple
speaker pairs simultaneously.
The control center lets you use one to four sets of speakers at a time, and is
designed to operate with a stereo receiver/ampli er that has a maximum of 50
watts per channel, and with speaker systems that have a minimum impedance
of 8 ohms (see "Impedance Chart" on page 5)
PREPARATIONS
•
Use the PYLE PRO Speaker Selectors only with ampli ers rated at 50 watts per
channel or less.
•
Your PYLE PRO Speaker Selector is designed to accept any size cable up to 14
gauge non-terminated speaker wire. If you're using non-terminated speaker
wire, do not use any speaker wire that is larger than 14 gauge. The lower the
gauge number, the larger the cable (e.g., 12 gauge is larger in actual physical
size than 14 gauge).
•
Do not hook the outputs of one selector into the inputs of another speaker
selector together.
MAKING THE CONNECTIONS
The control center divides the power from your receiver/ampli er di erently to
its speaker terminals. (This is especially noticeable when you connect only one
pair of speakers. If you connect more than one pair of speakers, see "Impedance
Chart" on page 5 to selector the best terminals to connect.)
For the best performance, make the connections based on how frequently you
use each set of speakers.
Terminal Buttons Protection Buttons
www.PyleUSA.com
3