Audizio Boston Record Player Set Bedienungsanleitung Seite 6

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must
be returned, it is important that the product is returned in the original factory box and packaging. If the device has been
exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising
condensation water might damage your device. Leave the device switched off until it has reached room temperature.
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the
mains voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The
unit must also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
1. Platter
Place your record here
2. 45 rpm adapter
This adapter allows you to play 45 RPM records
3. Tone arm lever
Use to raise/lower the tone arm
4. Auto-stop on/off
This switch turns the auto-stop function on/off. When the
automatic stop is enabled, the platform will start rotating as
soon as the tone arm is placed over the record and will stop
rotating when it has reached the end of the record. Some vinyl
records stop before the end or do not stop when the end is
reached. In this case set auto-stop to OFF
5. 33/45/78 RPM
Use to adjust the RPM of the turntable platter
6. Tone arm
The fixed tone arm can be raised and lowered by hand
7. Arm clip
This arm clip secures the tonearm while at rest or when not in use. The arm clip has been designed to remain in the up
position whilst unlocked
8. Stylus cartridge
Cartridge containing the stylus/needle
1. Headphone output
Connect your headphone with this 3,5 mm (1/8) jack
connector
2. IR
Receive the IR signal from the remote control
3. Display
4. CD tray
5. USB port
Port for USB stick, USB card reader or compatible external hard drive for playback
6. VU meters display
Analog VU meter's moving needle ballistics accurately reflect audio's average signal level
7. Standy
Press to power on/off
8. CD eject
Press to open/close CD tray
9. Play/Pause/Scan/Select/BT-pair button
Press to play/pause in BT/USB
Press and hold for scan in DAB/FM
Press to confirm in Menu
Press to pair in BT
10. /Menu
Press to enter Menu
Press to exit program in play mode CD/USB
11. –/Tune/Skip –
Press to change to the previous menu screen
Press to scroll through the available stations in FM/DAB
Press and hold button to scan down the frequency band
Press to change to previous track in CD/USB
6