Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remote
control
and receiver
Put the battery into the aircraft as shown In the figure, the aircraft taillight flashes quickly, turn
on the remote control switch, the aircraft prompt light flashes slowly. push the remote contro
throttle stick to the maximum and then pull it to the lowest, the aircraft indicator light is always
on, the frequency
is tied Success
Start your first
flight
1. Positioning
the aircraft
on the ground
aircraft is facing you.
2. As shown,
push the left rocker to lower left corner and the right rocker to
lower right corner, the motor start working, do same action again then
the motors
close
off.
3. When the motor starts within
3 seconds
motor will stop, need to re-breaking
take
off.
Note: After the aircraft landed on the ground, need to keep the throttle
stick in the lowest position 2-3 seconds, after the aircraft motors
are completely stopped then release the rockers
on the frequency
level to ensure that the tail of the
(3 seconds
can not afford the
rod start), gently push the throttle
-28-
A key takeoff
l. The aircraft and the remote control are completed. The aircraft is placed
horizontally
on the ground.
aircraft
will automatically
2. Press one key to take off/landing
aircraft
will automatically
rotating after landing. During the landing, the throttle stick is pushed up
to release the landing.
Calibration
1) When the aircraft during the flight there is a clear yaw and fine-tuning in the
case of the median, through the horizontal
2) as shown: the left and right joystick to move to the lower left comer position at
the same time 1-2 seconds, then the aircraft four comer ight flash, the aircraft
into the level of calibration, until the four corners of the aircraft indicator light is
it, the level Of calibration success
to
Special Note:
1 calibration to find a relatively level of the venue, as far as possible to ensure
that aircraft and ground level
2 After the aircraft enters the horizontal calibration
stationary
until the calibration
I a key landing
Press a key to take off/landing
take off and hover at a height
button
during flight.
land and the motor
will automatically
of aircraft gyroscope
calibration
calibration flight attitude
procedure,
is successfu
-29
-
button.
The
of about Imeters.
At this time, the
stop
"d
landing
keep the airplane
Werbung
