Cleaning And Maintenance - Maltec Mastercold Bedienungsanleitung

Cleaning and maintenance

Note for internal and external cleaning of refrigerator
 You must unplug the plug before cleaning.
 When cleaning, ensure that water does not enter the live area.
 Dip in with soft towel lukewarm water or neuter cleaner is swabbed except
the inside of the freezer outside door seal strip, outside surface.
 When cleaning door seals, clean them with clean water and dry cloth.
 Do not scrub with a cleaner that contains an abrasive (such as toothpaste),
an acid, a chemical solvent (such as alcohol), or a polish.
 Do not rinse with water.
Energy saving points
 Place the refrigerator in a dry and well-ventilated place, to ensure that the
refrigerator is not close to the heat source and not exposed to direct sunlight.
 High temperature foods should be cooled to room temperature and
refrigerated (please ignore this rule if heating is required).
 Shorten the opening time of the refrigerator.
Other things
 Power outage
Reduce the number of refrigerator doors (cover), avoid putting new food (to
prevent the temperature rise).
 Shutdown out of use
◦ If you need to shut down, you can just pull the plug.
◦ If you decide to leave the refrigerator out of usage for a period of time,
follow these steps: First, shut it off, then clean it, and finally, leave the door
(cover) slightly open to avoid odor.
◦ Note: If you decide to stop using the refrigerator, you cannot store any food
in the refrigerator.
 Non-fault analysis and elimination
◦ There is fog condensation on the outside of the refrigerator
◦ When the air humidity is high, this phenomenon will occur, just dry it.
◦ Storage room frost, condensation
Because the storage room refrigerator is close to the inner wall, when
working, the temperature here is low and frost, condensation phenomenon.
◦ Poor refrigeration effect in summer,
Because
temperature is higher for the normal phenomenon
the ambient temperature is
17/ 29
higher, the storage room