Travel Lock; Charging The Device - Wellshave 8317 Bedienungsanleitung

PACKAGE CONTENT (Fig. A)
Shaver x1 Trimmer x1 USB power cable x1
Protective cover x1 Rotating head x1 Cleaning brush x1
User manual x1

TRAVEL LOCK

• The shaver is equipped with a travel lock to prevent accidental turning on.
• Activate travel lock: press and hold the power button 3S, the indicator light converges
from the ends; the travel lock is activated
• and the shaver is locked (fig. B).
• Deactivate travel lock: hold down the power button 3S, the light spreads to both ends;
the travel lock is deactivated. (Fig. C)

CHARGING THE DEVICE

• Connect the USB charging cable to the applicable adapter and other power supply or
• directly to your computer. (Fig. D)
• Keep the product and USB charging cable dry while charging.
• The light blinks when the battery is low and continues to rise and fall during charging;
the light illuminates for 3 seconds and then blinks for 1 second to indicate that the
battery is fully charged. (Fig. E)
• Note: Use only the applicable adapter with this unit. It must be charged for at least 1.5
hours before first use. A 5-minute charge provides approximately one use.
SHAVING
• Press the power button to turn on the shaver. (Fig. F& J}
• Press the power button to turn the shaver off after use. (Fig. H&L)
• This shaver can be used with or without a cord. (Fig. F)
• Clean the shaver after each use with the brush provided and put on the protective cap
when not in use to avoid damage.
• Do not use it if the shaver is damaged as it may hurt your skin.
• DRY SHAVING (Fig. G}
• Best results are achieved when used on dry skin.
• It may take 2 to 3 weeks for skin to become accustomed to dry shaving.
• When shaving, apply only light pressure with straight and circular
• movements against the direction of beard growth.
• wet shaving (fig. G)
• You can also use this shaver on wet skin while showering with shaving foam or shaving
gel. Follow the steps below to shave with shaving foam or shaving gel:
• Apply water to your skin.
• Apply shaving cream or shaving gel to your skin.
• Rinse the shaver to allow it to glide smoothly over your skin.
TRIGGERING
• This operation requires replacing the attachment, see "Attachment Replacement and
Cleaning Instructions" to replace the trimmer head. {Fig. I)
• Use the trimmer head to shape your beard or sideburns. (Fig. K)
WARNING
• To avoid personal injury, keep this product away from water when charging.
• Be careful with the blades as they are very sharp.
• Never press on the blades and the shaving net, or on hard objects, as this may cause
irreparable damage to the shaver or its components.