PETKIT Eversweet Max Benutzerhandbuch Seite 7

Remove the Lid and Filter Holder: Gently lift the lid of the water tank along with the
filter holder. These components should be set aside on a clean surface. Inspect them for
any dirt or manufacturing debris, and rinse if necessary to ensure cleanliness before
use.
Install the Water Pump and Outlet Pipe
Place the wireless water pump into the groove inside the water tank. Ensure that
•
the pump sits firmly and securely in its designated position.
Next, take the outlet pipe and carefully insert it into the water outlet located
•
above the wireless water pump.
Push the outlet pipe firmly until it is fully secured. You should feel or hear a slight
•
click, indicating that it has been installed correctly.
Important Note: Always double-check that the outlet pipe is fully inserted to the end.
An improperly installed pipe can result in leaks or improper operation of the device.
Reattach the Lid and Install the Filter
Place the filter holder back into the designated slot as shown in the
•
illustration.
Insert the filter securely into the holder. Ensure that it is properly aligned for
•
effective filtration.
Place the lid back onto the water tank to complete this step.
•
7