equipment.
33. Never go to bed with the device on. Unplug the device from the
outlet.
34. Never cover the controller.
35. Before turning on the device, make sure it is evenly laid out and
has no kinks or corrugations.
36. The product can be washed in a washing machine at 30°C. It
can be washed by hand. Disconnect the power cord and controller
before washing. The switch or controller-controller must not be wet
during washing, and when drying, the cord must be in a horizontal
position to ensure that water does not flow into the switch or
controller-controller.
37. The device must not be ironed with an iron.
38. The device must not be used for medical purposes in hospitals.
This equipment is not intended for medical use in hospitals.
39. The device should cool down before storage.
40. The device can only be used with the types of detachable
components specified in the equipment labeling.
41. Do not use the device on adjustable beds, or if the device is
used on an adjustable bed, check that the blanket and cord cannot
get wedged or corrugated, such as on hinges.
Product: electric padded blanket MS7419 / MS7420
BEFORE FIRST USE
1) The product should be unfolded and laid flat before turning on.
Mount the product according to the instructions in the section: How to mount on the bed.
2) We recommend that you switch the unit to the maximum setting two to three hours before bedtime, and then reduce
to the desired heat setting 15 minutes before getting into bed. Before going to bed, the unit should be turned OFF.
The way to mount on the bed:
1. Place the product on the mattress with the control switch (or two) on the head side, but not extreme on the edge of
the bed, expand towards the feet.
2. The control switches should be below the normal head position when sleeping.
3. Unroll the binding straps and run the straps under the bed, as shown in the diagrams below (Fig.1-6).
4. Make sure the heating wires do not go under the pillows or hang over the sides. Put the middle tape under the
mattress and through the middle loop on the opposite side (fig.1). Pass the end of the tape under the corresponding
bottom corner of the mattress (fig.2) up through the middle loop of the product (fig.3) and down under the opposite
corner of the mattress, and then through the side loop on the opposite side of the product (fig.4).
5. Repeat this process at the other end (fig. 5).
DEVICE DESCRIPTION - mechanical controller
16