Maico R10 Gebrauchsanweisung Seite 22

- The product must be installed by professionally qualified
personnel.
- The product must be connected to the electricity supply
by means of a double-pole switch with a minimum contact
opening distance higher than 3 mm.
- Check that the amperage of the appliance complies with that
of the controller (see rating label Fig. A).
-The product is suitable for indoor application only.
R10 - R15: The remote electronic controller allows adjusting
the connected appliance speed, so to obtain different
performances.
Provided with:
1. ON/OFF switch (Fig.12-C), to activate/deactivate both the
controller and the connected unit.
2. Turning knob to adjust the speed (Fig.12-B).
3. Additional option: setting of the lower running speed of the
connected appliance.
-Turn first the setting knob (Fig. 12-B) to the minimum.
-Select the low running speed of the appliance by turning
the trimmer (Fig.12-A). It is recommended that the low
running speed is not settled beneath the 50% of the high
running speed.
R10 TIMER: The remote electronic timer allows setting
the overrun time from ±3' to ±25'. After switching off, the
connected appliance continues to run until the preset period
has elapsed.
Provided with:
1. ON/OFF switch (Fig.12-F). ON to activate the connected
appliance. OFF: the connected unit continues to operate
until the preset time is over.
2. Turning knob to adjust the overrun time (Fig.12-E).
R10 HY: the remote electronic humidity controller automatically
switches on/off the connected appliance when the percentage
of relative humidity in the room is over/beneath the preset
level.
OPERATION
21