Jasper Morrison MP 01 Kurzanleitung Seite 12

the equipment and shall be
easily accessible.
Sound pressure safety
Use carefully with
the earphone as an
excessive sound pressure from
earphones and headphones can
cause hearing loss.
Caution
Risk of explosion if battery is
replaced by an incorrect type.
Dispose of used batteries
according to the instructions.
Proper use
As described in this manual,
your device can be used only in
right location. If possible, please
do not touch the antenna area
on your device.
FCC Regulations:
This device complies with part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) This device may
not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause
undesired operation.
This mobile phone has been tested
20
and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation.
This equipment generates, uses
and can radiated radio frequency
energy and, if not installed
and used in accordance with
the instructions, may cause
harmful interference to radio
communications. However, there
is no guarantee that interference
will not occur in a particular
installation. If this equipment
does cause harmful interference
to radio or television reception,
which can be determined by
turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
— Reorient or relocate the
receiving antenna.
— Increase the separation between
the equipment and receiver.
— Connect the equipment into
an outlet on a circuit different
from that to which the receiver
is connected.
— Consult the dealer or an
experienced radio/TV technician
for help.
Changes or modifications not
expressly approved by the party
responsible for compliance
could void the user's authority to
operate the equipment.
RF Exposure Information (SAR)
This device meets the government's
requirements for exposure to
radio waves. This device is designed
and manufactured not to exceed
the emission limits for exposure to
radio frequency (RF) energy set
by the Federal Communications
Commission of the U.S. Government.
The exposure standard for
wireless devices employs a unit
of measurement known as the
Specific Absorption Rate, or
SAR. The SAR limit set by the
FCC is 1.6 W/kg. *Tests for SAR
are conducted using standard
operating positions accepted
by the FCC with the phone
transmitting at its highest certified
power level in all tested frequency
bands. Although the SAR is
determined at the highest certified
power 20 level, the actual SAR
level of the phone while operating
can be well below the maximum
value. This is because the
phone is designed to operate
at multiple power levels so as
to use only the poser required
to reach the network. In
general, the closer you are to a
wireless base station antenna,
the lower the power output.
The highest SAR value for the
model phone as reported to
the FCC when tested for use at
the ear is 0.603W/kg and when
worn on the body, as described
in this user guide, is 0.495W/
kg (Body-worn measurements
differ among phone models,
depending upon available
enhancements and FCC
requirements.) While there
may be differences between the
SAR levels of various phones
and at various positions, they
all meet the government
requirement.
The FCC has granted an
Equipment Authorization
for this model phone with all
reported SAR levels evaluated
as in compliance with the FCC
RF exposure guidelines. SAR
information on this model
phone is on file with the FCC
and can be found under the
21