Searching Satellite - Travel Vision R6 Benutzerhandbuch

3.5

Searching satellite

After connecting the wiring as described in section 3.4, the wiring as described in section 3.4, switch on your satellite receiver and television. Then
connect the control module to the antenna system by pressing it firmly into its socket.
On the display of the control module the following will be then shown: On the display of the control module the following will be
This last message will disappear within a few seconds, after which the system will present
this level, you can select the satellite of your choosing. this level, you can select the satellite of your choosing.
During its first usage, the system will preselect the Astra1 satellite. The system will store and remember During its first usage, the system will preselect
previously selected satellite(s) and will show it ellite(s) and will show it on the display after startup.
List of preprogrammed satellites from which you can choose: List of preprogrammed satellites from which you can choose:
Satellite Position
Astra 1 19,2 E
Astra 3 23,5 E
Astra 2 28,2 E
Hotbird 13
Hellassat 2 39
Turksat 42
Eutelsat 9 9
to the antenna system by pressing it firmly into its socket.
TRAVEL VISION
FIRMWARE V****
within a few seconds, after which the system will present the satellite menu. At within a few seconds, after which the system will present
ASTRA1 19.2°
TURN LNB TO 0
Satellite Satellite Position
Eutelsat 7 Eutelsat 7 7
SES 5 SES 5 5
Thor Thor 1
E Eutelsat 5 Eutelsat 5 5
E Eutelsat 12 Eutelsat 12 12,5 W
E Telstar 12 Telstar 12 15
E Hispasat Hispasat 30
Recreation
BOOTING
∞
The system will store and remember
E
E
W
W
W
W
and television. Then
page 9