Viking SR32 Bedienungsanleitung Seite 5

EN
Thank you for choosing a VIKING product. Please refer to the technical specifica�ons of each model in the user manual or on the website
www.best-power.cz .
Before using
1. Do not install the light under shade or between buildings. Otherwise, this will lead to insufficient absorp�on of sunlight and insufficient charging.
2. Do not use the light in an environment with a temperature above 60°C or below -20°C, otherwise rapid ba�ery fade and deple�on will occur. This will affect
ba�ery life and may even damage the ba�ery.
3. Do not use non-standard accessories to install the light.
4. Select the appropriate ligh�ng mode according to the local sunshine.
5. Charge the product every 3 months to ensure that the lithium ba�ery is ac�ve.
6. If you store the product for more than one year, perform a full charge and discharge check and make sure the ba�ery is in good condi�on, otherwise it is
forbidden to use it!
Installa�on and use
Choose a suitable loca�on for the solar LED light where there is sufficient and as long las�ng exposure to sunlight as possible.
Remove the bracket from
the light body.
Switching the light off and on
Press the ON/OFF switch for 1.5s
to switch on/off. A�er the first ac�va�on, the light
will automa�cally turn on/off when it gets dark/dawn.
Light modes
Briefly press the ON/OFF switch to change the light mode:
M1 mode: 25% brightness un�l dawn
M2 mode: 50% light brightness un�l dawn
M3 mode: 75% brightness un�l dawn
M4 mode: 100% light brightness un�l dawn
Maintenance
1. Keep the light away from fire and oil to avoid fire or explosion.
2. If the light is not charged for 3 days, it is possible that the ba�ery will run down and must be charged in bright sunlight.
3. In order to keep the light working in op�mal condi�on for a long �me, clean the solar panel regularly according to local condi�ons, we recommend at least
once every six months.
4. Long-term sta�c storage of the product for more than one year will cause damage to the inside of the ba�ery or even drain it. If the ba�ery leaks, it may
cause spontaneous combus�on.
Package contents:
1 piece - Viking SR32 Outdoor Solar LED Light
Outdoor solar LED light Viking SR32
2
3
Drill holes in the wall and
insert dowels for sea�ng
the expansion bolts.
Product Descrip�on:
1. Solar panel
2. ON/OFF switch
3. Body of light
4. Led light
4
A�ach the bracket to the wall and fix
it with the spreader screws.
BONA SPES s.r.o.
Hang and fasten the body
the light to the bracket.