TecTake 404317 Installationsanleitung Seite 2

STEP7
Install left and right light strips
A
x6
①
D
x1
②
A
D
USB cable goes out along
the reserved hole.
Use 5x5 allen key (D) to install light strips to the tabletop with screw (A).
STEP8
Connecting cables
2
B
Insert
2
The port for plug wire is beneath the tabletop.
Plug wire
⑧
USB cable
⑩
Do not connect the power before
the wiring is completed.
USB cable goes out
17
along the reserved hole.
USB cable
Tear off Manage
B
Cable
B
Lighting control instructions
⑨
Upper left and right light
strips go from the ports
of bottom light strips.
How to use handset
Height Adjustable Function:
If the LED display can show the current height, press
" " or " " button can adjust the table height. Long press can
enable continuous rise or go down and meantime the light
starts to flicker.
Height Memory Function:
Click "M"button and LED display shows "
button from " ", "
Motor cable
the meanwhile, the light flickers meaning the data has been
successfully saved. Click the corresponding button and then
the desk can be adjusted to the saved height.
Reset Function:
1. When the height is different with the LED display or it shows
default code, you need to reset the desk.
2.Press and keep "
down to the lowest place. Then long press the "
more than 3 seconds to enter the reset process and LED
display shows " "or "
until it bounce up and the LED display shows the current
height, which means the reset is a success.
Insert
Anti-Collision Sensitivity Adjustment:
B
1.Simultaneously press and hold the "
three seconds to switch the sensitivity, one operation to switch
one level, divided into 4 levels,
Fix
2.The display shows "
closed; the display shows "
B
display shows " " means medium sensitivity; the display
shows " " means low sensitivity.
3.When the desk go up or down, it will rebound immediately
when encountering obstacles to prevent itself.
Button
LED Display
". Then click any
", "3", "4"to achieve the height setting. In
Button introduction
①
②
③
④
" button to adjust the desk until it goes
" button for
⑤
down
⑥
". Then long press the " " button
⑦
Code Processing:
1.When the LED display shows "
reset function.
" and " " buttons for
2.If "E01" or "E02" appears, please let the desk rest for more
than 18 minutes before it can be used normally.
, , , .
3.If other codes appear and there is no response after pressing
" means the anti-collision function is
the "
" means high sensitivity; the
and the connection is normal, and power off for more than 10
seconds, then turn on the power again, "
displayed, then long press the "
4.If the above operations are performed, the table still does not
operate normally, please contact customer service.
Light switch Power switch
Light switching instructions:
After the USB is powered on, the light strip turns
on for 3 seconds and then you can switch the light.
Light Switch Options: Green/blue/red/cyan/yellow/
purple/white/seven-color gradient light/flashing light.
Touch control.
Button 'stand', suitable for standing, the first height data saved by users
Button 'sit', suitable for sitting, the second height data saved by users
Function key, use with other buttons
Position 3, the third height data saved by users
Position 4, the fourth height data saved by users
Upper button, adjust the desk to rise
Downward button, adjust the desk to go down
" or " ", please refer to the
" button, please make sure that the cable is not damaged
" or " " is
" button to reset.