Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Empty the tank before moving it.
• Do not drink fog liquid, otherwise seek medical advice immediately. Use clean water to wash skin and eyes if
fog liquid has come into contact with them.
DISCONNECT DEVICE: The power outlet must be installed near the equipment and be easily accessible.
MOUNTING
• It is important never to obstruct the path of the fan or vents. Mount the unit in a level position.
• When choosing a location for the unit, ensure that it is easily accessible for filling the tank and routine main-
tenance.
• Never mount the fixture where it will be exposed to rain, high humidity, extreme temperature changes, or
restricted ventilation.
• If the external flexible cable or cord of this unit is damaged, it must only be replaced by the manufacturer or
its service agent or a similarly qualified person to avoid danger.
FUSE REPLACEMENT:
Warnings: Disconnect the power cord before replacing a fuse and always replace with the same
type of fuse.
Unscrew the fuse holder from its housing, remove the damaged fuse and replace with exactly the same type of
fuse. Screw the fuse holder back in its place and reconnect power.
Exterior surface temperature under steady state conditions is 60°C.
OPERATION:
1. Please turn on the unit via the switch on the rear panel. The machine will start heating up. When it has
reached operating temperature, the red LED on the wired remote control lights up. When the LED goes off,
the unit has cooled down and requires re-heating, the pump will not operate and the LEDs don't light up
whilst the heater is on. The switch will illuminate when the machine is again ready to use.
2. Press the A button on the remote control to switch the LEDs off.
3. Press the B button on the remote control activate the LEDs in music controlled mode.
4. Press the C button on the remote control select a color.
5. Press the D button on the remote control to produce fog for 30 seconds.
6. Often check whether there is enough fog liquid in the tank. The machine might be severely damaged if it
runs without fog liquid.
7. If the fog output is low, the unit makes an unusual noise or there is no fog output at all, please power off
and check fog liquid, fuse and power plug. If the problem hasn't been solved after checking these parts,
send it back to your dealer for repair.
INSTALLING THE BATTERY IN THE REMOTE CONTROL
• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow to slide the battery compartment open.
• Remove the old battery and install the new one (23A 12V alkaline) with the correct polarity.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in
accordance with your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.
CLEANING:
AFTER EACH USE, REMOVE THE HOSE FROM THE TANK AND PRESS THE REMOTE CONTROL TO SPRAY
FOG UNTIL ALL FOG FLUID HAS BEEN REMOVED FROM THE CONDUITS! FAILURE TO DO SO WILL
CLOG THE MACHINE!
Unplug the machine from the mains prior to cleaning, refilling the tank, changing the fuse, repairing or doing
any other maintenance.
All fog machines are prone to clogging due to the consistency of fog fluid and the high temperatures at which it
Code: 15-1313PLS
3
Werbung
