Werbung
Verfügbare Sprachen
Verfügbare Sprachen
instruction Manual
Dear customer,
Please read these operating instructions through carefully before connecting your device to the mains, in
order to avoid damage due to incorrect use. Please pay particular attention to the safety information. If you
pass the device on to a third party, these operating instructions must also be handed over.
PREPARATioN BEfoRE USE
•
Make sure the use rate current not less than 10A, and no other high power appliance is plugged into the
same socket.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
WARNiNG: This tool must be placed on its stand when not in use.
• The depth of heater in the charcoal can not exceed the position of illustration:
PRoDUCT illUSTRATioN
oPERATioN
• Take up the firelighter from the base.
• The metal container fulfilling charcoal must be placed on the level and stable surface, insert the
firelighter into the charcoal.
• Put the firelighter's heating part close touch the charcoal adequately; connect the appliance to the
power supply socket.
• In 10 - 15 minute, the charcoal will be fired.
• After the charcoal fired, disconnect the power, Unplug the firelighter before removal from the fire.
Carefully pull out the firelighter from the charcoal and put it on the base for cooling.
SAfETy CAUTioN
• Ensure the firelighter is properly positioned, placed on a stable, secure surface.
• Do not place the firelighter on flammable, explosive tabletop (such as wooden, rubber, glass tabletop).
• Do not put the power cord close to the fire, high temperature or under the carpet, blankets.
•
Never try to touch / clean / move the heater before it is cooled down.
• The connected socket of firelighter, its extension cord and rate current should not less than 10A.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
RC 2.3-12.A
Electric BBQ Grill lighter
↑
Maximun depth
Heater
Base Plastic handle Wire
-
4 -
Werbung
