TecTecTec STPRO 1 Benutzerhandbuch Seite 6

7. Calibration
If you experience
1.The tilt (pitch) angle is not level with the horizontal surface.
2.The roll angle is not parallel to the horizontal surface.
3. The panning angle drifts while in lock mode.
Calibration Instructions
Step 1: Power on the gimbal (this will take around 3 seconds), press and hold the
middle button of the joystick for over 6 seconds until the status indicator
light is solid.
Step 2 : Lay the gimbal on a static, flat surface (See the picture above) and make sure
it is not shaking. Calibration is finished when the status indicator light is
continuously flashes three times.
Step 3: Power off the gimbal and restart it. If the calibration was unsuccessful, repeat
steps (I )(2) to reinitialize.
8. Disclaimer
1. Please install and use the product according to the manual!
2. Keep the battery away from fire and sources of heat!
3. Use for any illegal purpose is strictly prohibited. Users will be responsible for
their own behavior after purchasing and using the products.
Initialization
any of the following
O
o
while using the gimbal, please calibrate it