TecTecTec STPRO 1 Benutzerhandbuch Seite 4

*Charging: Using the standard USB CABLE
connect to the Gimbal charging port (or
another power source)
3. Mount and Balance
The stabilizer is perfectly compatible with all our XPRO cameras as well as the Her05/4/3 or
other action cameras
3.1 Two Camera
The STPRO 1works well using either camera installation.
1.To control your camera easily the lens
should be near the pitch motor so that
you can click the control button.
3.1ndicator Li
Signal Indicator Light
Light stays on : Bluetooth is connected
Light turns off : Bluetooth is not connected
Two flashee : Power on/ Off
the Action Camera
of similar size.
Installation Methods
4. Power
To power on the Gimbal press and hold the function button
until the indicator light flashes twice.
ht Function
Step 1 :Move the tilt (pitch) motor to either
the LEFTor the RIGHT side, and place the
XPRO Camera close to the clip as shown.
Step 2 : Tighten by the 2 ong screws wel
to prevent violent movement.
2. If you want to charge the camera while
using the STPRO,the lens should be
opposite the pitch motor so you can use
the charging cord easily.
On
Status Indicator Light
Flashes once : Panning mode
Flashestwice : Panning and tilting (pitching) mode
Flashes three
Consistent flashing : Low battery/Charging
Light stays on : Charging finished
times : Lock mode