x-sense RC01 Pro Bedienungsanleitung Seite 4

Pairing the Remote Controller with the
"ense Wireless Interlinked
(Purchased Separately)
L Create an interlinked group of wirelessalarms
by following The operating instructions
included with the device packaginy
2. Press the test/silence
interlinked alarm in the interlinked group 4
times. The unit will beep once, and the red
LEOwill flash slowly. indicating it hasentered
pairing mode and iswaiting for a new unit to
be added
Press the test/5iIence
controller twice The LEDwill flash rapidly,
indicating that it is searching for a device to
connect to
After successful linking, the alarm will beep
once and automatically exit the pairing
mode After this, the alarm will only flash once
per minute, indicating that it is in normal
monitoring mode The LEDindicator on the
remote controller will light up for about
seconds, then turn off
Alarms
button an one wireless
button on the remote
Testing the Wireless Connection
the Wireless Interlinked
Hold down the test/silence
within range of the remote controller The LED
indicator on the remote controller
After the wireless interlinked
received the signal (takes about 7 seconds).
their LEDindicators will flash, and all wireless
interlinked alarms will sound
3 Release the test/silence
indicator on the remote controller will stop
flashing, indicating that the test has ended. All
alarms should go silent.
Silencing the Wireless Interlinked
Simply press the test/silence button to silence the
wireless interlinked alarms to silence a false alarm
such asfumes from cooking, cigarette smoke, etc
NOTE:NEVER silencean alarm thar you do not know
the origin of Alwaysinvestigatean alarm BEFORE
silencing!
During an alarm, press the test/silence button
once, and all devices paired to the wireless
interlinked alarm that initiated
Between
Alarms
button While
should flash.
alarms have
button The LED
Alarms
the alarm will be