Premise - Duolabs Cas Interface 3 Benutzerhandbuch

1. Premise

Cas Interface 3, the evolution of Cas Interface 2, combines in a single product
all the features of Cas Interface 2, its Add-on and many additional options.
This new release offers very advanced technical features. As compared to Cas
Interface 2, it enables to fully manage PCMCIA connectors and easily connect
external additional modules.
However, the most interesting novelty derives from the possibility of being
able to emulate the PCMCIA port of a Common Interface (EN50221) receiver
and thus use the Cam directly as if it were inserted in a receiver.
Consequently, Cas Interface 3 can also be used by professionals to test a CAM
(Conditional Access Module) without inserting it in a receiver.
Cas Interface 3 also enables users to manage and program several types of
SmartCards, which includes both current ones and those yet to be developed.
Cas Interface 3 can therefore be regarded a multifunction programmer suitable
for the management of J-Tag, ISP, I2C, etc., through a USB port.
Cas Interface 3 supports the programming and reparation of the following
modules:
Magic Cam, Matrix Cam, Matrix Revolution, Matrix Reloaded, Matrix Reborn,
•
and all CAMs based on SIDSA chipsets, which can be managed directly by
means of a PCMCIA connector. For a full list of supported modules, open the
Graphics Menu of Cas Studio. Remember to download the latest release from
www.duolabs.com.
Joker Cam, Zeta Cam and substantially all CAM modules based on NEOTION
•
chipsets. These modules can be programmed and repaired using a J-Card.
For a full list of supported modules, open the Graphics Menu of Cas Studio.
Remember to download the latest release from www.duolabs.com.
Dragon Cam; it is possible to program any version by inserting the Dragon
•
Cam into Cas Interface 3 and using a Dummy Card. This mode eliminates
the need of inserting the Drag Cam into a receiver, which can sometimes
damage the CAMs besides being unpractical. It is also possible to repair
faulty Dragon Cams if they fail to initialize due to a faulty Flash Memory. To
do so, it is sufficient to open the module and connect a few wires, following
a procedure that can be easily implemented even by less expert users.
X-Cam, with ANGEL and ORION chipsets, standard and premium version. It
•
is possible to program any version by inserting the X-Cam into Cas Interface
3 and using a Dummy Card. This mode eliminates the need of inserting the
X-Cam into the receiver, which can sometimes damage the CAMs besides
being unpractical. It is also possible to repair faulty X-Cams if they fail to
initialize due to a faulty Flash Memory. In this case it is necessary to open
the module and connect a few wires, following a procedure that can be
Cas Interface 3 – Benutzerhandbuch
www.duolabs.com
4
– alle Rechte vorbehalten.