USING THE LAMP
•
The lamp can be operated by pressing the ON/OFF button directly to switch it on or off or to change its
colour. The remote control can also be used.
•
To switch on, press the ON/OFF button.
•
Press the ON/OFF button again to change the colour.
•
Keep the button pressed and the lamp will go out.
CLEANING
•
Clean the lamp with a damp cloth. Do not use detergents or other chemical products, which could damage
the coating of the lamp.
INFRARED REMOTE CONTROL
HOW TO USE
Make sure there are no obstacles in the path of the infrared signal from the
remote control to the LED lamp. The range of the remote control is 1 to 5
metres, depending on the environment in which the LED lamp is used.
R
R
. . . . . . . . . . . . . . . . . . . .
G B
G B
ON
. . . . . . . . . . . . . . . . . . . . . . . . .
OFF
. . . . . . . . . . . . . . . . . . . . . . .
COLOR SELECTION
. . . .
FLASH MODE
. . . . . . . . . . . .
STROBE MODE
. . . . . . . . . .
FADE MODE
. . . . . . . . . . . . .
SMOOTH MODE
. . . . . . . . .
NOTE
•
Before using the remote, remove the plastic tab from the battery compartment.
•
If the remote doesn't appear to be working after you have pushed the buttons several times, put it down
for 1 minute, then move nearer to the lamp and begin again.
•
The remote can be used on more than one lamp but you will need to be closer to the lamp than normal in
order to ensure you are changing the correct lamp.
•
Indoors, due to interference from other domestic appliances, it may be difficult to use the remote from a
distance of 5m. If so, get nearer to the lamp.
Remote control reference
Remote control frequency
Battery type
09/10/2024
Adjust the level of light
Switch on the LED
Switch off the LED
Choose a colour from the 16 available
Continuous automatic colour change
Very fast automatic colour change
Automatic colour change with the colours fading into one another
Automatic colour change with the colours fading into one another slowly
REMOTEAG01 (SW-RM001)
38MHz
CR2025 (3V)
OFF
ON
R
G
B
W
FLASH
STROBE
FADE
SMOOTH
15
EN