AUS micro32 Handbuch Seite 14

The CONTROL-BALL's 230 Vac power supply must be on
the same line as the MICRO32 feed so that the same
switch can turn each unit on or off.
Even through operating with a 24 Volt insulating system,
the ball BOXes are equipped on the inside with a faston
d e v i c e i n o rd e r t o b e c o n n e c t e d t o t h e e l e c t r i c a l
grounding system.
On the CONTROL-BALL board, a red light indicates:
flashing light: the connection to the MICRO32 is okay
light always on: the unit is not connected to the
MICRO32
light off: the CONTROL-BALL is either broken or
has no power supply.
The CONTROL-BALL may also be connected to simple
balls containers in which the withdrawal of the tray turns
on a micro-switch. In this case, the game start takes place
automatically when the tray is taken out. If you wish that
automatic START to be a club operation, you can regulate
it before or within one minute of the tray's extraction by
pushing the START-CLUB button and then the button for
the table involved. The two micro-switch wires are
connected in the same way as the two BOX wires.
NOTES
Containers of CONTROL-LAMP and CONTROL-BALL are
in material Class: IEC 650.
If the wiring is not fitted with protection from short circuits
and indirect contacts for all equipment, this must be
carried out by the client.
T h e M a n u f a c t u re r d e c l i n e s a l l re s p o n s i b i l i t y i f t h e
equipment is tampered with.
We reserve the rights to carry out changes without
prior notice
12
ENGLISH