Create Studio Bedienungsanleitung Seite 7

• Make sure that electrical appliances, cords and plugs do not come into con-
tact with heat sources, such as a hot hob or open fire.
• Never let cords hang over the edge of the sink, a worktop or a table.
• Always remove plug from the socket when you are not using the electrical
appliance.
• Remove the plug from the socket by pulling the plug itself and not the cord.
• Regularly check if the cord of the electrical appliance is not damaged. Do
not use the electrical appliance if the cord shows signs of damage. If the
cord is damaged, it should be replaced by the manufacturer, a technical
service provider or a person with an equivalent qualification, to avoid any
danger.
• The appliance may not be switched on with the aid of an external time
switch, or by a separate system with remote control.
• Be careful when using the appliance outdoors.
• Never use the appliance in damp or wet locations.
• Thoroughly clean the appliance after use (see Cleaning and Maintenance).
1. Slot for toasting bread
2. Lift lever
3. Roast controller
4. Reheat button
5. Cancel button
6. Defrost button
7. Crumb tray
8. Heating rack lever
9. Heating rack
B E FO RE U SE
Operate the toaster a couple of times, without bread, at the maximum setting. This will re-
move the last traces from the manufacturing process. A little smoke and odour may be emit-
ted by the toaster when it is used for the first time.
P RE PAR ATI ON
1. Put the appliance on a stable and flat surface.
2. Put the plug into the wall socket.
PARTS LIST
OPERATING INSTRUCTIONS
E NGLI SH
7