GE RC24T/R Bedienungsanleitung Seite 6

FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Battery Recycling
The battery must be recycled or disposed of properly, according to the national and local
regulations. If you have any questions, contact your local dealer.
Connecting the Remote Control with the USLT-USB and SpotChecker
1. After Switching on the instrument
(SpotChecker or PC with UltraLog
Software) the remote control needs to be
initialized.
Simultaneously press key 1 and 8 of the
remote control until the red LED lights up.
2. Press key 1 of the remote control and the
LED will flash slowly.
Keep key 1 pressed and hold the remote
control as close as possible to the receiver
(or SpotChecker respectively) until the red
LED flashes in short sequence. The
transmitter is now assigned to the receiver.
Note:
In case the remote control won't work properly after having assigned it to the instrument,
it might be required to select the corresponding application window from the UltraLOG
software by clicking on it using the mouse, trackball or touch screen before the
programmed functions of the remote control will be available.
GEISTIGES EIGENTUM VON GE
106M5976
RC24T/R - Remote Control for USLT-USB and SpotChecker
User Manual
Seite 5 von 8
Rev. -