Safety Information
-
The RC24 Remote Control is intended for use with UltraLog-, or USLT2000 Software.
It is not allowed to control elements of functional safety. Please mind, every software
running on the system can be affected by the remote control.
-
Use only commercially available 1.5V Batteries of AAA Size.
-
Observe the plus (+) and minus (-) marks on battery and equipment and ensure correct use.
-
Do not mix batteries of different manufacture, capacity, size or type within the remote
control.
-
Do not place the battery in fire or exceed the battery operating temperature.
-
Do not short-circuit a battery.
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interferences in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Consult the dealer or an experienced radio/TV technician for help.
GEISTIGES EIGENTUM VON GE
106M5976
RC24T/R - Remote Control for USLT-USB and SpotChecker
User Manual
Seite 4 von 8
Rev. -