Technical Data - Mesko Ms 7058 Bedienungsanweisung

19. Do not direct the suction tube of the vacuum cleaner towards other people or animals.
20. Only vacuum dry surfaces.
21. Use only accessories intended for this device.
22. Be especially careful when vacuuming the stairs, take care of your own safety .
23. Do not block any ventilation openings.
24. Do not run the vacuum cleaner without the filter in place.
25. Do not pull the vacuum cleaner by the hose.
26. Be careful that the power cord is not caught in a door or jammed. Pay attention to the
length of the power cord when moving the vacuum cleaner. Sudden pulling of the
vacuum cleaner with a taut cable may damage it.
26. Do not vacuum dust and construction residues, residues of this type of contamination
immediately void the warranty.
27. Do not leave the device unattended during operation.
28. Always unplug the appliance when left unattended and before assembling,
disassembling or cleaning.
29. Before removing the plug from the socket, always switch of f the device with the button.
Device Description Vacuum cleaner:
1. Power cable 2. Handle
User Before first use:
1. Remove all packing material
2. Clean the device using with a damp cotton cloth
THe device consists of:
1x Main engine unit with filter and dust cup
Note: Always remove the plug from the socket before mounting or removing accessories.
Attaching slotted tools to the device
1. Make sure the device is turned off.
2. Insert the telescopic tube (7) / Floor brush (5) / 2 in 1 brush (6) into the dust container front hole.
3. You can attach any ot the attachments onto the telescopic tube.
4. To extend the telescopic tube (7) press the button on the side of the tube and pull on either side it will extend.
Cleaning the device:
1. Grab the dust container ( firmly.
2. Move over a dust bin and turn it counterclockwise. The open lock symbol on the side of the dust bin should align with the outcrop.
3. Open the dust bin and remove the dust from the bin.
4. Grab the filter inside firmly and turn it counterclockwise to release it.
5. Using a brush clean the filter. You can also wash it in clean water. Do not soak the filter. After washing leave it in a dry place for 24
hours or until fully dry. DO NOT USE THE FILTER UNLESS FULLY DRY, even after cleaning the filter the suction power might drop.
If it happens replace the filter. You can buy it at your retailer. Ask for filter model: MS 7058.1
6. Replace the filter by putting it back and twisting it clockwise to attach it correctly into place. Please note that incorrect installation of
the filter or using the device without a filter will lead to device failure.
7. Clean the dust cup using a damp cotton cloth. Then using a dry cotton cloth wipe it completely dry.
8. Replace the dust cup back into its place and turn it clockwise to fasten it into place.

TECHNICAL DATA

Power source: 220-240 V ~ 50/60 Hz
Power: 400 W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
3. Switch 4. Dust cup 5. Floor brush
1x floor brush 1x telescopic aluminium tube
6. 2 in 1 brush 7. Telescopic aluminum tube
4
1x 2in1 brush