•
N ever make any modifications or
alterations to the PUQpress. The
manufacturer holds no liability for
damages resulting from failure to
observe these instructions.
•
Never drop the PUQpress and avoid
bumping. Not doing so results in the
PUQpress getting damaged.
•
Never unplug the PUQpress by pulling the
cable. Always grasp the plug and pull.
•
Always place the PUQpress on a level,
vibration-free surface.
•
Never operate the PUQpress in moist or
wet conditions.
M ake sure the portafilter (group handle)
•
does not wiggle after adjusting.
•
Make sure not to use a damp/wet cloth
to clean the tamper base. Grounded
coffee will stick to the tamper base.
•
Never install the PUQpress in an area
where a water jet can be used.
Never clean the PUQpress with a jet of
•
water or a steam cleaner.
1.2
Personnel requirements
The user of this PUQpress does not need
special requirements. Ensure you have fully
read and understood the instructions in this
document before you install or use the
PUQpress. Keep this document for future
reference.
1.3
Explanation of the symbols on the
product and packaging
Electronic equipment needs to
bear the CE mark in order to be
marketed in the EU. CE marking
shows that a product is assessed
before being placed on the
market and that it meets EU
safety, health and environmental
protection requirements. CE
marking is also sometimes
accepted as a means of
compliance with type-approval
requirements; for example,
electronic components that
require type-approval and also CE
marking for electromagnetic
compatibility (EMC) or low-voltage
equipment.
Indication that the PUQpress is an
Electrical class | product, with
provided means for the
connection of conductive parts
(which are not live parts) to the
protective (earthing) conductor in
the fixed wiring in such a way that
these parts cannot become live in
the event of a failure of the basic
insulation.
Indication that the PUQpress is
fragile.
Indication that the PUQpress
must be kept dry.
Indication that the PUQpress
must be handled with care.
Indication that the packaging of
the PUQpress must be handled
this way up.
11
EN