APW Mesa ANC Bedienungsanleitung Seite 9

INSTRUCTIONS
Charging
Fully charge the headphones before using it for the first time.
Plug the end of the cable into the USB-C port on the headphones. Plug the other end into
a computer or adapter (adapter not included; required parameters: 5 V / 1 A).
The LED indicator will glow red.
When the headphones are charged, the LED will turn white. Disconnect the charging cable
from the headphones and the computer or charger.
Note: When not using the headphones for longer periods, continue to charge them regularly.
Pairing
When using for the first time:
Switch on the headphones using the MFB button. The headphones will automatically switch
to pairing mode.
Turn on Bluetooth on your mobile device and start searching for available devices.
Select the APW Mesa ANC headset model from the list displayed to start automatic pairing.
When the headphones are paired, the white LED will flash slowly (about once every 10 sec-
onds).
Re-pairing with an already paired device:
Switch on the headphones using the MFB button. The headset will automatically connect to
the most recently paired device.
Pairing with another device
Turn off the Bluetooth on the device to which the headphones were connected.
The LED light should now alternately flash red and white. If this does not happen, please reset
the device to factory settings and try again.
Turn on Bluetooth on your mobile device and start searching for available devices.
ENGLISH 9