Beatfoxx CDB-1016 BK Bedienungsanleitung Seite 21

AUX-In Operation:
This unit provides an AUX IN JACK (#23) for connecting external audio devices like
MP3 players, CD players, smart phones and iPods (except iPod shuffle 3rd
generation) to listen to your external source through the speakers of this system.
1.
You need an audio cable (not included) with one 3.5 mm stereo plug on each
end of the cable.
2.
Plug one end of the cable into the AUX IN JACK (#23) located on the left hand
side of the unit and the other end of the cable into the Line-out Jack or
Headphone Jack of your external audio device.
3.
Turn on the external audio device.
4.
Turn on the unit by setting the FUNCTION SELECTOR (#24) to CD/AUX
position.
5.
The volume level can now be controlled through the VOLUME CONTROL
(#5) of the unit. Operate all other functions on the auxiliary device as usual.
6.
Set the FUNCTION SELECTOR (#24) to OFF/TAPE position to turn off the
unit.
•
If you connected the Line-out Jack on your external device then you only
need to adjust the volume control of this system. If you connected the
Headphone Jack of your external device then you may need to adjust both
the volume control of your external device and the volume control of this
system to find the most desirable volume setting.
•
Remove the audio cable from AUX IN JACK (#23) when you finish
listening. Don't forget to switch off the power on your external device as
well.
Playing a tape:
Check the following items before starting operation.
•
Use Type I (normal) tapes only. Type II (high position), Type III (ferro-
chrome) and Type IV (metal) tapes are not supported.
•
If there is tape slack, rewind the slack using a pencil to avoid
damaging the tape or the unit
1. Press , insert a cassette tape into the cassette tape compartment (#19)
and then close the compartment cover.
2. Press to start playback.
Other operations:
To
Stop playback
Pause playback
Fast-forward or rewind
Eject the cassette
Do this
Press
Press , To resume playback,
press the button again
Press or
Press