iOttie iTap 2 Wireless Handbuch Seite 3

Metal Plate Alignment
The Qi Receiver Coil is usually located in the center area of the phone. Check
with your phone's manufacturer for Qi coil location.
for commonly used phones.
O We stronglysuggestyou usethe includedPlacementGuideto place
the Metal Plate at the bottom of your smartphone or case for receiving
an optimal charge.
iTap 2 Wireless
'Phone X
0
Qi coil
oo
Magnets Metal Plate
Samsung
Galaxy sg
iTap 2 Wireless
00
Guide
Below are some examples
iPhone XR iPhone XS Max
o
Samsung Samsung
Galaxy S9+ Galaxy Note9
o
A. Align the + symbol and the side
marker lines with the center of your
phone or case, making sure the
cut-out for the Metal Plate is at the
bottom.
B. Once aligned, remove adhesive
strip at the top and stick the
Placement Guide to phone.
o
Place one of the Metal Plates
as indicated by the cut-out on
the Guide. Save the other Metal
Plate as backup.
A. Lift the Guide from the bottom
to stick the Protective Film onto
the area where the Metal Plate
will be.
B Put Placement Guide back
down, flat against your phone
or case.
2A
Please note, the protective film
is not necessary if you're using a
phone case.
o
Remove the placement guide.
Then, simply position the metal
p ate on top of the magnetic
mount head.
2B