Declaration
of Conformity
Changes or modifications
not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
You can refer to the following completed
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
interference that may cause undesired operation.
Note
This equipment
has been tested
and found
Class B digital
device,
pursuant
to Part 15 of the FCC Rules. These
designed
to provide
reasonable
protection
a residential
installation.
This equipment
radio frequency
energy and, if not installed and used in accordance
the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment
does cause
television reception, which can be determined
and on, the user is encouraged
to try to correct
more of the following
measures:
• Reorient
or relocate
the receiving
• Increase
the separation
between
the equipment
• Connect
the equipment
into an outlet
which
the
receiver
is connected.
• Consult the dealer or an experienced
(FCC)
FCC warnings.
received, including
to comply
with the limits for a
limits are
against
harmful
interference
generates,
uses and can radiate
with
harmful
interference
to radio
by turning the equipment off
the interference
by one or
antenna.
and receiver.
on a circuit
different
from that to
radio/TV technician for help.
Operational
O
During the charging process, the transfer of electricity gives off heat. Your
device
may become
If the device gets wet, please cease charging immediately.
O
and dry the product
indoor
environment.
O
Please be careful of excessive drops, dents, punctures, or deformities on the
device. If you are concerned,
the
manufacturer.
O
Changes or modifications
for compliance could void the user's authority to operate
the equipment.
O
Operating this device in a hot environment or in direct sunlight for a long
period of time may cause malfunctions. We recommend keeping the product
in cooler
temperatures.
O
Please use included components for an optimal experience. To support Qi
in
wireless charge when using a third party car charger or a USB Power Adapter
use a minimum output of both "9.0V-1.67A or 5.0V-2.OA" and at least QC 2.0.
O
The product's signal could possibly interfere with you TPMS (tire pressure
monitoring system). If you notice that your TPMS light turns on, please try
using your mount in different locations to avoid the signals from interfering
or
with
each
other.
O
California Proposition
of California to cause cancer and birth defects or other reproductive
Caution
OLD
WITH
Warnings
warm, but should
not become
completely.
Device
is only to be operated
please unplug the device and contact
not expressly approved by the party responsible
65 this product contains chemicals known to the state
ELECTRICAL
APPLIANCES
MUST
NOT BE DISPOSED
THE
RESIDUAL
WASTE,
BUT HAVE
TO BE DISPOSED
exceedingly
hot.
Remove all plugs
in a dry,
harm.
OF TOGETHER
OF SEPARATELY.