Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Example: to search for your Television Code:
SSC
e
=
Changing the Device keys
——
1.
Switch your Television on (not on standby).
If you want, you can change any of the device keys to
2.
Press the TV key on your TOTAL
operate another
t
f
d e v i
o
CONTROUS:
p
other type of device.
Example 1:
3.
Press and hold down the SETUP key
To program a Television on the AUX 2 key
o
until the red light (LED under POWER
(for example), you need to change the AUX 2 key
key) on the TOTAL CONTROL 8 blinks
into UN key, so press:
d
**
twice.
®
ooo
—
0
-
EN )
4. O
€» ER
Press 9 9 1, the red light will
i
The AUX 2 key has now become a TV key.
blink twice.
Now enter the Set Up code for your TV
5.
Next, press POWER.
by pressing:
kk
®
—
@ —
C]
mess'
)
6.
Aim the TOTAL CONTROL 8 at your
Television. Now press CH+ over and over,
Example 2:
until your aor ips e iia time
To programa Television on the SAT key (for
you press
the
CH+ key
the
|
CONTROL 8 will send out a POWER signal
Se
you need to change the SAT key into a TV
from the next code contained in the
ey, Sg
quí)
memory). You may have to press this
»
E
key many times (up to 150 times) so
©
oee
o
©
please be patient.
The SAT key has now become a TV key.
If you skip past a code, you can go to the
Now enter the Set Up code for your TV
previous code(s) by pressing the CH- key.
by pressing:
Remember to keep pointing the TOTAL
(**)
CONTROL 8 at your Television while
© >
@ > [____] (code)
pressing this key.
SETUP to store the code.
To reset the AUX 2 key to its original mode,
press:
instructions above only press the appropriate device
key instead of TV during step 2.
- if the original remote control of your Video recorder
or DVD player does not have a POWER key, press
(*)
Press and hold down the SETUP key until
PLAY instead of POWER during step 5.
the red light (LED) blinks twice.
(**)
The red light (LED) blinks twice.
Werbung
