Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting up your TOTAL CONTROLS
_ —
Example: to set up the TOTAL CONTROL 8 for
yourTelevision:
1.
Switch your Television on (not on standby).
2.
Find your device code in the code section (page
73 - 94) Codes are listed by brand name. The
most popular code is listed first. Make sure your
television is switched on (not on standby).
"o
'©
Press and release the TV key on your
TOTAL CONTROL 8
Then press and hold down the SETUP
key and keep it pressed until the red
light (under the POWER key) blinks twice.
Enter your 4-digit code, using the
number keys. The red light blinks twice.
Now, point the TOTAL CONTROL 8
towards your Television and press the
POWER key. If your Television switches
off, the TOTAL CONTROL 8 is installed.
-0
- Most TV's do not switch back on pressing the
POWER key, please try pressing a "number" key to
switch your TV back on.
- If your device does not respond, follow steps 2
through 6 with each code listed for your brand. If
none of the codes listed for your brand operate your
device, then try the Search Method described on
page 6 - 7, even if your brand is not listed at all.
- Some codes are quite similar. If your device does not
respond or is not functioning properly with one of
the codes, try another code listed under your brand.
|
- If the original remote control from your Video
Recorder / DVD player did not have a POWER key,
press PLAY instead of POWER during step 6.
- To set up your other devices, follow the same
instructions above, only press the appropriate device
key during step 3.
- Remember to press the correct device key before
operating your device. Only one device can be
assigned to a device key.
w `
HIE
w 0000
EE
ERR
-a KICHE
DVD
MAA
"TESI
SAT
|
||
se
LE
If your device does not respond to the TOTAL
CONTROL 8 remote after you have tried all the codes
listed for your brand, you may need to search for your
code. This method may also work if your brand is not
listed at all.
Werbung
