Uk: Instruction Manual - Outwell Merapi Pro Duo Deluxe Bedienungsanleitung

UK: INSTRUCTION MANUAL

OPERATION
• CAUTION: Use outdoors only.
• When in use, the appliance should be placed in a well-ventilated location, protected
from direct draughts.
• Accessible parts may be very hot. Use gloves and sturdy, long-handled barbecue tools when cooking.
• Keep young children away from the appliance.
• Do not misuse the appliance or use it for other purposes than those for which it is intended.
• Do not modify any parts of the appliance.
• Never leave the appliance unattended when lit.
• Do not attempt to repair the appliance. If you are not able to rectify any fault following these
instructions, contact the dealer or Outwell Customer Service (contact details below).
• Do not use the appliance if it is leaking, damaged, or not functioning properly.
• The appliance must be operated on a stable, horizontal, and non-combustible surface.
• Handle the appliance with care. Ensure it is not dropped. Do not move the appliance during use.
• Check that seals are in place and in good condition before connecting to the gas cartridge. Do not use
the appliance if a seal is damaged or worn.
• The appliance must be used away from flammable materials, maintaining minimum distances from any
adjacent surfaces (walls, ceiling) as shown below.
Rubber washer (14)
Sealing O-ring (15)
6
CONNECTING YOUR APPLIANCE TO A GAS CARTRIDGE
1. To use your appliance, you will need to purchase a gas cartridge that is suitable for this specific
appliance. Please refer to the TECHNICAL DATA table for information regarding the gas cartridge.
2. Position the gas cartridge at the side of your appliance, at least 200 mm away from the appliance. Keep
in mind that the cartridge must be kept away from heat and in a safe, upright position.
3. Ensure that both burner knobs (8 + 9) are closed by turning them fully clockwise towards the small "•"
symbol.
4. Firmly push the cartridge connector into the regulator socket. At the same time, twist the cartridge
clockwise to securely fasten it into the regulator socket, as shown in Picture C. Take care not to cross-
thread (hand-tight only).
5. Test for potential gas leaks by applying soapy water to the connection points. If bubbles form, there
is a leak. Leaks may also produce a noticeable odor or a "hissing" sound. If a leak is detected, check all
connections and fittings until the leak is resolved.
LIGHTING YOUR GAS APPLIANCE
1. Ensure your gas appliance is assembled, and the gas cartridge is connected according to the
instructions above.
2. To light the appliance, decide which burner to ignite, and turn the knob (8) for the left burner or (9) for
the right burner counterclockwise to release the gas (see Pictures D and E).
D
3. Push and hold the auto piezo ignition button for the left or right burner (7) to ignite the burner.
4. If it fails to ignite after pressing the button 3-5 times (within 5 seconds), immediately close the knob
(turn it towards the small "•" symbol) and wait 5 minutes to allow the unburned gas to dissipate before
making another attempt.
5. When the burner is lit, turn the control knob(s) (8 + 9) clockwise to decrease the heat intensity or
extinguish, and counterclockwise to increase the heat to achieve the desired level for cooking.
UK: INSTRUCTION MANUAL
C
E
7