Avocent SwitchView 100 Schnellinstallationsanleitung Seite 2

NOTE: Optional software for advanced control of your USB-enabled SwitchView switch is available. Visit www.avocent.com to download this application at no cost. This
software is not required for your unit to operate, and is only needed for additional control of your USB-enabled SwitchView switch. This application will need to be loaded on
each PC attached to your switch in order for you to utilize these additional controls.
Command
Select PC Channel
(Audio and mic are bound)
Select PC Channel
(Audio and mic are bound)
USA Notifi cation
Warning: Changes or modifi cations to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Canadian Notifi cation
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the
Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe B prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le Ministère des Communications du Canada.
European Union Declaration of Conformity
This equipment has been tested and found to comply with the limits for a Class B computing device in accordance with the specifi cations in the European standard
EN55022. These limits are designed to provide reasonable protection against harmful interference. This equipment generates uses and can radiate radio-frequency
energy, and if not installed and used in accordance with the instructions, might cause harmful interference to radio or television reception. However, there is no
guarantee that harmful interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment on and off, you can correct the interference with one or more of the following measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and the receiver.
c) Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
d) Consult the supplier or an experienced radio/TV technician for help.
To Contact Avocent Technical Support: Visit www.avocent.com
Avocent, the Avocent logo, The Power of Being There and SwitchView are registered trademarks of Avocent Corporation or its affi liates. All other marks are the property of their respective owners. ©2007 Avocent Corporation. All rights reserved.
Hotkey Push-Button
ScrLk + ScrLk N/A
NumLk + NumLk N/A
Description
Select the active PC channel (joint select PC port/
hub port control/audio & mic if binding is enabled)
Select the active PC channel (joint select PC port/
hub port control/audio & mic if binding is enabled)