RND power RND 320-00168 Bedienungsanleitung Seite 3

INSTEAD OF THE DC INPUT SOCKET A FIXED CONNECTING CABLE HAS BEEN USED
WHEN CONNECTED TO ANY APPLIANCE, BE SURE TO TURN ON INVERTER
FIRST. AND THEN TURN ON THE POWER SWITCH OF THE APPLIANCE.
DO NOT USE THE INVERTER BEYOND ITS MAXIMUM OUTPUT POWER.
WHEN CONNECTED TO ANY APPLIANCE MAKE SURE THE TOTAL
STARTING POWER CAPACITY DOES NOT EXCEED THE MAXIMUM
OUTPUT POWER OF THE INVERTER.
3
EN
Condition
Input Over Voltage
Low battery alarm:
Overheating alarm:
Overload alarm:
Note: BEEE is a 2-sec long beep, BEE is a 1-sec long beep, BI is a short beep.
CAUTION : DO NOT REVERSE INPUT. USE RED BATTERY CORD TO CONNECT (+)
OF A DC BATTERY TO (+) TERMINAL. AND THEN, USE BLACK BATTERY CORD TO
CONNECT (-) BATTERY TO (-) TERMINAL.
WHEN THE INVERTER OPERATES IN FULL OUTPUT CAPACITY FOR A LONG
PERIOD, THE TEMPERATURE OF THE INVERTER WILL INCREASE AND
POTENTIALLY SHUT DOWN BY THE OVER-TEMPERATURE PROTECTION.
THEREFORE, IT IS RECOMMENDED TO REDUCE THE AC OUTPUT CAPACITY
IF A LONG CONTINUOUS OPERATING TIME IS REQUIRED.
DO NOT USE THIS DEVICE WITH FLUORESCENT LAMPS.
Warning signal cycle Shutdown signal cycle
No Warning Signal Continuous tone
BEEE (cycling) Continuous tone
BEEE(cycling) Continuous tone
BI (cycling) Continuous tone
WARNING FLUORESCENT LAMP
EN
4