Ego Power+ CS1200E Bedienungsanleitung Seite 12

TROUBLESHOOTING
EN
WARNING:
Always protect your hands by wearing heavy gloves when performing any maintenance on the saw
chain. Always remove the battery pack when servicing or transporting the chain saw.
PROBLEM
Motor does not run.
Chain saw stops
unexpectedly during
operation.
Motor runs, but chain
does not rotate.
Chain brake does not
engage.
12
56 VOLT LITHIUM-ION CORDLESS TOP HANDLE CHAIN SAW — CS1200E
CAUSE
◾
The battery pack is not attached to the
chain saw.
◾
No electrical contact between the saw
and battery pack.
◾
The battery pack charge is depleted.
◾
The battery pack or chain saw is too
hot.
◾
The locking tongue is not depressed
before pressing the trigger switch.
◾
Chain brake is engaged.
◾
Saw chain is bound in the wood.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
A 4.0Ah or higher Ah battery pack is
used.
◾
The chain saw is overloaded.
◾
The battery pack or chain saw is too
hot.
◾
Saw chain is bound in the wood.
◾
Chain does not engage drive sprocket.
◾
Debris preventing full movement of the
chain-kickback brake paddle.
◾
Possible chain brake malfunction.
SOLUTION
◾
Attach the battery pack to the chain saw.
◾
Remove battery pack, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw to
cool until the temperature drops to the
recommended operating temperature
range.
◾
Press down the locking tongue and hold it,
then depress the trigger switch to turn on
the chain saw.
◾
Pull the chain-kickback brake paddle
backward toward the front handle, to the
operating position.
◾
Release the trigger switch; remove the saw
chain and guide bar from the wood, then
restart the chain saw.
◾
Press the saw chain against the wood,
move the chain saw back and forth to
discharge the debris.
◾
Remove battery pack, then remove side
cover and clean out debris.
◾
Use only with EGO 2.5 Ah battery packs
BA1400 and BA1400T.
◾
Decrease the load.
◾
Allow the battery pack or chain saw to
cool until the temperature drops to the
recommended operating temperature
range.
◾
Release the trigger switch; remove the saw
chain and guide bar from the wood, then
restart the chain saw.
◾
Remove the battery pack and reinstall the
chain, making sure that the drive links on
the chain are fully seated on the sprocket.
◾
Clean debris from the external chain brake
mechanism.
◾
Stop using the chain saw immediately!
Contact EGO Customer Service for repair.