Ego Power+ CS1200E Bedienungsanleitung Seite 11

MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician.
WARNING:
To avoid serious personal injury,
always remove the battery pack from the product before
inspecting, cleaning, or performing maintenance. A battery
operated tool with the battery pack inserted is always on
and can start accidently.
WARNING:
When cleaning the chain saw, DO NOT
immerse it in water or other liquids.
WARNING:
Do not at any time let brake fluids,
petrol, petroleum-based products, penetrating oils,
etc., come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic, which may result in
serious personal injury.
CLEANING
◾
After each use, clean debris from the chain and guide
bar with a soft brush. Wipe the chain saw surface with
a clean cloth moistened with a mild soap solution.
◾
Remove the side cover, and then use a soft brush to
remove debris from the guide bar, saw chain, sprocket
and side cover.
◾
Always clean out wood chips, saw dust, and dirt from
the guide bar groove when replacing the saw chain.
GUIDE BAR MAINTENANCE
When the guide bar shows signs of wear, disassemble
it from the chain saw power head and reverse it for
reassembly (Fig. R1). This way the wear will be distributed
to maximize the guide bar life.
The bar should be cleaned every day of use and checked
for wear and damage. Feathering or burring of the bar
rails is a normal process of bar wear. Such faults should
be smoothed with a file as soon as they occur. A bar with
any of the following faults should be replaced.
◾
Wear inside the bar rails which permits the chain to lay
over sideways.
◾
Bent guide bar.
◾
Cracked or broken rails.
◾
Spread rails.
In addition, the guide bar has a sprocket at its tip
(Fig. R2). The sprocket must be lubricated weekly with a
56 VOLT LITHIUM-ION CORDLESS TOP HANDLE CHAIN SAW — CS1200E
grease syringe to extend the guide bar life. Use a grease
syringe to lubricate weekly with chain oil by means of the
lubricating hole (Fig. R3). Turn the guide bar and check
that the lubrication holes and chain groove are free from
impurities.
R-1 Sprocket in Guide Bar Tip
R-2 Lubricating Hole
TRANSPORTING AND STORING
◾
Do not store or transport the chain saw when it is
running. Always remove the battery pack before
storing or transporting.
◾
Always place the chain sheath on the guide bar and
chain before storing or transporting the chain saw. Use
caution to avoid the sharp teeth of the chain.
◾
Always carry the product by its front handle.
◾
Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
◾
Clean the chain saw thoroughly and empty the oil tank
before storing. Store the chain saw indoors, in a dry
place that is locked and/or inaccessible to children.
◾
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
PROTECTING THE ENVIRONMENT
Do not dispose of electrical equipment,
used battery and charger into household
waste!
Take this product to an authorized recycler
and make it available for separate
collection. Electric tools must be returned
to an environmentally compatible recycling
facility.
EN
11