N-Gear RG200 Bedienungsanleitung Seite 7

Button instruction
1. Power on [power off
Long press about 3 seconds to power on /power off
2. TWS button
Single click : to enter into /exit TWS function
1) Prepare two speaker ,single click this button for either of them,will hear a voice prompt .(PS:PIease
make sure the speaker is disconnected with any wireless device before using TWS function )
2) Then wait for a few seconds, will hear a voice prompt after the two speaker connected with each
other successfully. Search for the bluetooth ID to connect with bluetooth device.
3) After connected with bluetooth device, operate either speaker,the other one will be synced.
4) Single click TWS button of either of them will exit TWS mode.
3.Pause /play
3.1 Single click to pause /play music
3.2 Long press to exit or re-connect Bluetooth connection
3.3 Under wireless connection
call;double click to call back last phone; long press to reject the phone call
4." M" button
Single click to switch playing mode ,from wireless mode - TF mode - U disk mode - AUX mode (Note: This
operation should be under TF card, U-disk, AUX all insert on the speaker in advance)
5. Light button
Single click to switch the light ; Long press to turn on /turn off the light ;
6. " +" Button
Single click to increase volume ,
Long press to go to next song
button
7.
Single click to reduce the volume
Long press to go back last song
8. AUX jack
Standard 3.5mm headphone jack
9.USB jack
When insert a U-disk , the default playing is U-disk playing mode
TF card support 32GB maximum
IO.TF jack :
When insert a TF card, the default playing is TF card playing mode
TF card support 32GB maximum
11. Type-c jack
Insert the type-c charging cable to charge the speaker
mode, single click to answer/hang up the phone when there is incoming